15. MAJOR UNIT REPLACEMENT EM18-33031
15.15 INTERFACE CARDS
15-31
15.15 INTERFACE CARDS
1) Remove the side panel (L). (Refer to Section 3.2.)
2) Each Interface card is being held by 2 screws.
3) After removing the 2 screws, push the card to the inside and remove the connector from the Main PCB
Board.
Expansion I/O Interface
Serial Interface
Parallel Interface
(Note: For GS/TS16
models, this slot is used
for WLAN Interface)
See Section 4.6 for details
Expansion I/O Interface Card
Expansion I/O Interface Card
Back View
Side View
To Next Page
Loading...
