Toshiba B-EX6 Series - Auto Print (Trans.); Auto Print (Refl.)

5. SYSTEM MODE EM18-33031
5.6 TEST PRINT
5-49
5.6.7 AUTO PRINT (TRANS.)
The factory test print is performed on the following conditions, therefore, the parameter settings and the
print density fine adjustment value are ignored.
Key functions after printing of each test pattern are as follows.
 [ENTER] key (or its substitute key): Next printing is performed.
 [CANCEL] key (or its substitute key): The display returns to the menu.
 Other keys: Invalid
<Factory test print patterns and print conditions>
Print test pattern 1 blank label
3-dot slant lines
Barcode
Characters
Issue count 5 labels each
Print speed 203 dpi 5 ips
305 dpi 5 ips
Sensor type Transmissive sensor
Print method Thermal transfer
Issue mode Batch issue
Label pitch 76 mm
Print density fine adjustment value ±0
5.6.8 AUTO PRINT (REFL.)
The factory test print is performed on the following conditions. Therefore, the parameter settings and
the print density fine adjustment value are ignored.
Key functions after printing of each test pattern are as follows.
 [ENTER] key (or its substitute key): Next printing is performed.
 [CANCEL] key (or its substitute key): The display returns to the menu.
 Other keys: Invalid
<Factory test print patterns and print conditions>
Print test pattern 1 blank label
3-dot slant lines
Barcode
Characters
Issue count 5 labels each
Print speed 203 dpi 5 ips
305 dpi 5 ips
Sensor type Reflective sensor
Print method Thermal transfer
Issue mode Batch issue
Label pitch 76 mm
Print density fine adjustment value ±0