Toshiba B-EX6 Series - Rf Channel; Retry; Retry Position; Retry Lables

5. SYSTEM MODE EM18-33031
5.10 RFID
5-70
5.10.2.4 RF CHANNEL
A channel used for RFID tag write is set.
・ AUTO
・ 2CH
・ 3CH
・ 4CH
・ 5CH
・ 6CH
・ 7CH
・ 8CH
NOTES:
1. When a channel is chosen from 2CH to 8CH, that channel will be continuously used.
2. When the channel is set to AUTO, an available channel is searched in the following order:
(2CH
 8CH  6CH  4CH  3CH  7CH  5CH  2CH)
3. The channel setting works effectively only for the B-EX706-RFID-U4-R(*).
*: The frequencies used for the B-EX706-RFID-U4-R are as follows.
Channel 2CH 3CH 4CH 5CH 6CH 7CH 8CH
Frequency (MHz) 921.0 921.2 921.4 921.6 921.8 922.0 922.2
5.10.3 RETRY
The parameters related to retry are set.
The menu structure of RETRY menu
Menu item
<7>RFID
RETRY
RETRY POSITION
RETRY LABELS
READ RETRY
WRITE RETRY
5.10.3.1 RETRY POSITION
Max.
value
Min. value Step Display Sign
Integer
digit
Decimal
place
0-padding
Unit of
measure
+99 -99 1 Decimal None 2 0 None mm
If writing data on a tag failed, the printer feeds the RFID tag forward or backward for specified length,
in order to retry data write. When “0” is set for this parameter, a retry is not performed.
Only the value of -3mm or less or +3mm or more is effective.
5.10.3.2 RETRY LABLES
Max.
value
Min. value Step Display Sign
Integer
digit
Decimal
place
0-padding
Unit of
measure
255 0 1 Decimal None 3 0 None Labels
When issuing an RFID tag failed, the printer prints the error (Void) pattern, and retries to issue a tag for
up to the specified number of times. If the printer does not succeed even after having retried for the
specified number of times, the printer stops, resulting in an RFID WRITE error.