5. SYSTEM MODE EM18-33031
5.12 USB MEMORY
5-80
5.12 USB MEMORY
Contents of USB MEMORY menu
Menu item
<9>USB MEMORY
USB TO PRINTER
PRINTER TO USB
NOTES:
1. The following table shows the error messages and descriptions which may be displayed while USB
memory is used:
After the error message is displayed, the operation is not retried.
Message Description
FORMAT ERROR
Check the settings.
Format error or no memory installed
MEMORY WRITE ERR.
Check the data
and the settings.
Write error
MEMORY READ ERR.
Check the data
and the settings.
Read error
MEMORY FULL
Free some memory
space.
Insufficient memory
FILE NOT FOUND
Check the data
and the settings.
No applicable file found
UNKNOWN ERROR Other errors
2. Depending on the remaining memory size or the USB memory status, a write error may occur even in the
case of insufficient free space.
3. Usable USB memory’s file system is as follows. To use other file system in USB memory, they need to be
formatted to either of the following on the PC in advance.
File system Max. size
FAT (FAT16) 2GB
FAT32 8GB
5.12.1 USB TO PRINTER
・ COPIED DATA
・ CONFIG FILE
NOTES:
1. The data store in USB memory is copied to the printer.
COPIED DATA File (*.DAT) containing firmware (BOOT/MAIN/CG/KANJI/HTML), storage area
data, and parameter settings
The file is created in binary format when “PRINTER TO USB” is executed.
CONFIG FILE File (*.CFG) in which the path of the firmware (BOOT/MAIN/CG/KANJI/HTML) is
saved
The file is created in text format when the master media is made. The format of
the file is described in Section 8. Auto Configuration Mode. When an item to be
saved is selected, the file selection screen is shown.
To Next Page
Loading...
