EO18-33031
TABLE OF CONTENTS
Page
1. UNPACKING -------------------------------------------------------------------------------------------------------- 1- 1
1.1 PROCEDURES ---------------------------------------------------------------------------------------------------1- 1
1.2 CHECKS ------------------------------------------------------------------------------------------------------------1- 3
2. PRINTER INSTALLATION -------------------------------------------------------------------------------------- 1- 3
3. NOTE FOR OPTIONAL EQUIPMENT INSTALLATION
/MAJOR UNIT REPLACEMENT/MAINTENANCE ---------------------------------------------------- 3- 1
3.1 OPENING/CLOSING THE TOP COVER -------------------------------------------------------------------3- 3
3.2 REMOVING THE SIDE PANEL (L) --------------------------------------------------------------------------3- 3
3.3 OPENING/CLOSING THE PRINTER BLOCK ------------------------------------------------------------3- 4
3.4 REMOVING THE OPERATION PANEL --------------------------------------------------------------------3- 5
4. INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT ------------------------------------- 4- 1
4.1 DISK CUTTER (B-EX206-QM-R) ----------------------------------------------------------------------------4- 2
4.2 FANFOLD PAPER GUIDE MODULE (B-EX906-FF-QM-R) ------------------------------------------ 4-12
4.3 PEEL-OFF MODULE (B-EX906-H-QM-R) ---------------------------------------------------------------- 4-13
4.4 EXPANSION I/O INTERFACE BOARD (B-EX700-IO-QM-R) --------------------------------------- 4-24
4.5 WIRELESS LAN BOARD (B-EX700-WLAN2-QM-R) -------------------------------------------------- 4-27
4.6 PARALLEL INTERFACE BOARD (B-EX700-CEN-QM-R) ------------------------------------------- 4-34
4.7 SERIAL INTERFACE BOARD (B-EX700-RS-QM-R) -------------------------------------------------- 4-36
4.8 UHF RFID KIT (B-EX706-RFID-U4-US/EU/CN-R) ----------------------------------------------------- 4-38
4.9 4” ROTARY CUTTER (B-EX206-R-QM-S) --------------------------------------------------------------- 4-60
5. SYSTEM MODE ---------------------------------------------------------------------------------------------------- 5- 1
5.1 OUTLINE OF THE SYSTEM MODE ------------------------------------------------------------------------5- 1
5.2 REFLECTING THE SYSTEM MODE SETTINGS TO THE PRINTER ------------------------------5- 2
5.3 RESET ---------------------------------------------------------------------------------------------------------------5- 2
5.4 DIAGNOSTIC ------------------------------------------------------------------------------------------------------5- 3
5.4.1 MAINTENANCE COUNTER ------------------------------------------------------------------------5- 3
5.4.1.1 COUNTER PARAMETER PRINT CONTENTS --------------------------------------5- 6
5.4.2 AUTO DIAGNOSTICS ------------------------------------------------------------------------------ 5- 22
5.4.2.1 AUTO SELF DIAG. PRINT PRINTOUT ---------------------------------------------- 5- 23
5.4.3 HEAD CHECK ---------------------------------------------------------------------------------------- 5- 24
5.5 SET PARAMETERS ------------------------------------------------------------------------------------------- 5- 25
5.5.1 MEDIA LOAD ---------------------------------------------------------------------------------------- 5- 26
5.5.2 FEED KEY -------------------------------------------------------------------------------------------- 5- 26
5.5.3 MOVE TO TEAROFF ------------------------------------------------------------------------------ 5- 26
5.5.3.1 MOVE TO TEAROFF POS. ------------------------------------------------------------- 5- 27
5.5.4 FW/BK ACT. ------------------------------------------------------------------------------------------ 5- 27
5.5.5 RIBBON SAVE. -------------------------------------------------------------------------------------- 5- 27
5.5.6 HEAD UP CUT/RWD. ------------------------------------------------------------------------------ 5- 28
5.5.7 PRE PEEL OFF ------------------------------------------------------------------------------------- 5- 28
5.5.8 BACK FEED SPEED ------------------------------------------------------------------------------- 5- 28
5.5.9 AUTO HEAD CHECK ------------------------------------------------------------------------------ 5- 28
(Revision Date: Oct., 2018)
To Next Page
Loading...
Need help?
General
