5. SYSTEM MODE EM18-33031
5.8 RAM CLEAR
5-60
WRITE AGC AGC threshold for data write 0
RETRY MIN AGC AGC threshold lower limit for retry 0
TAG CHECK RFID error tag detection Not cleared
MULTI WRITE Hibiki tag multi-word write OFF
CALIB. MODE RFID calibration mode OFF
CALIB. AGC Optimum AGC value obtained through
RFID calibration
0
CALIB. POSITION Distance to the optimum read/write
position obtained through RFID
calibration
+000.0mm
ANTENNA POSITION Position of the RF antenna and the wave
director
Not cleared.
SUCCEEDED TAGS Number of times data write succeeded Not cleared.
VOID PRINT TAGS Number of times data write failed Not cleared.
<< RTC >>
Item Description Initial value
BATTERY CHECK Battery check Not cleared.
RENEWAL Time update timing Not cleared.
Settings not printed on the maintenance counter/parameter setting data printout
System mode:
<12>Z-MODE
Item Initial value
Z-MODE OFF
User system mode:
<5>SHOW ISSUE COND.
Item Initial value
Sensor
(Note)
TRANSMISSIVE
Mode BATCH
Print Speed 203 dpi: 5 ips
305 dpi: 5 ips
Ribbon
(Note)
RBN w/o save
Direction BOTTOM
Media pitch
(Note)
203 dpi: 76.0mm
305 dpi: 76.0mm
Print length 203 dpi: 74.1mm
305 dpi: 74.2mm
Print width 203 dpi: 160.0mm
305 dpi: 160.0mm
Media width Not cleared
NOTE: Though the setting value is reset to the initial value by a parameter clear, the first online operation
after a parameter clear is performed based on the value set with the initial setting wizard.
To Next Page
Loading...
