5. SYSTEM MODE EM18-33031
5.18
PASSWORD
5-92
Password entry for user system mode
NOTE:
If you forgot the system mode password, disable it with @010 command
Display Procedure
Turn on the printer, press the [PAUSE] key to place the printer in pause
state. Then, hold down the [MODE] key for 3 seconds.
The password entry screen is displayed.
Enter the password.
The printer enters the user system mode.
When a wrong password is entered or the [CANCEL] key or [MODE] key is pressed
Password invalid message is displayed.
A wrong password was entered for 3 times consecutively.
The printer locks. Turn off printer and back to on.
To Next Page
Loading...
