10. ON LINE MODE EM18-33031
10.4 ONLINE MODE LCD DISPLAY
10-6
RFID icon
Displayed and used when the RFID module is mounted.
Appears when a communication between the printer and the RFID
module is enabled.
Blinks during a communication with the RFID module.
- The communication includes the one without radio wave output.
- Blinks after radio wave output is instructed to the module even when no
radio wave is output.
(Blinks while the module stops outputting radio wave or changing the
channel under the influence of other carrier.)
ON: Module type is set and ready to communicate
Blink: Communicating
Ribbon near end icon
Ribbon near end is detected.
Blinks when the ribbon is close to the end.
Ribbon near end is detected depending on the diameter of unused
ribbon. 38 mm is equivalent to 30-meter ribbon and 43 mm is
equivalent to 70-meter ribbon.
Blinking: Ribbon near end state (*4)
(*4) Icon blinks at a 1-second interval (ON for 500 msec. and OFF for 500 msec.)
To Next Page
Loading...
