10. ON LINE MODE EM18-33031
10.6 MANUAL THRESHOLD SETTING
10-15
3: Transmissive sensor (when using
preprinted labels)
No setting is necessary.
4: Reflective sensor (when using a
manual threshold value)
No setting is necessary.
6) Press the [MODE] key.
→ The system mode menu is displayed.
7) Turn off the power, and back to on.
→ The printer is placed in the online state.
8) Send an Issue Command to make the printer print.
→ If a paper jam occurs or the media does not stop at the print start position, retry the threshold setting.
To Next Page
Loading...
