13. PERIODIC MAINTENANCE PROCEDURE EM18-33031
13. PERIODIC MAINTENANCE PROCEDURE
13- 4
10. Conduct the following tests and make sure that there is no problem.
(1) Print test with TOSHIBA TEC-approved media and ribbon. (Print tone, print head position, etc.)
(2) Print start position adjustment (Horizontal: media position, vertical: sensor adjustment/adjustment
by issuing commands.)
(3) Communication test
(4) Abnormal noise
(5) Confirm that there are not any other errors.
11. Close the top cover.
12. Clean the outside of the printer.
13. Fill out a report form. Hand it to the manager and obtain a signature.
To Next Page
Loading...
