15. MAJOR UNIT REPLACEMENT EM18-33031
15.6 RIBBON MOTOR SENSORS (TAKE-UP, FEED)
15-12
5) Replace the ribbon motor sensor (take-up) with a new one, then reassemble in the reverse
order of removal. At this time, take care of the following points.
Attach the ribbon motor sensor (take-up) to the ribbon sensor plate (take-up) in the correct
direction.
Fit the positioning tabs of the ribbon sensor plate (take-up) into the positioning holes in the
ribbon motor mounting plate.
Positioning Tab
Positioning Hole
Ribbon Sensor Plate (Take-up)
Ribbon Motor Mounting Plate
To Next Page
Loading...
