15. MAJOR UNIT REPLACEMENT EM18-33031
15.6 RIBBON MOTOR SENSORS (TAKE-UP, FEED)
15-14
5) Replace the ribbon motor sensor (feed) with a new one, then reassemble in the reverse order of
removal. At this time, take care of the following points.
Attach the ribbon motor sensor (feed) to the ribbon sensor plate (feed) in the correct direction.
Fit the positioning tabs of the ribbon sensor plate (feed) into the positioning holes of the ribbon
motor block.
Positioning Tab
Positioning Hole
Ribbon Sensor Plate (Feed)
Ribbon Motor Mounting Plate
Gear with Slits
To Next Page
Loading...
