15. MAJOR UNIT REPLACEMENT EM18-33031
15.7 PRINT HEAD
15-16
1) Open the top cover. (Refer to Section 3.1.)
2) Turn the head lever to the FREE position to open the ribbon shaft holder plate.
(Refer to Section 3.3.)
3) Open the print head block.
4) Pull the print head ass’y in the direction indicated by the arrow, and disconnect the two harnesses to
detach the print head ass’y.
Print Head Ass’y
Print Head Harness
Printer Block
Printer Head Block
Holder Plate
Print Head Block
To Next Page
Loading...
