4. INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT EO18-33031
4.3 PEEL-OFF MODULE (B-EX906-H-QM-R)
4-16
4. Insert the connector of Rewinder Harness, disconnected from the Rewinder PC Board in Step 2, into the
hole in the main frame.
5. Pull out the Rewinder Harness from the opposite side, and re-connect it to CN1 on the Rewinder PC
Board.
Rewinder Harness
Hole
Rewinder Harness
CN1
Rewinder PC Board
Hole
Tabs of Blind Plate
(→ Step 7)
To Next Page
Loading...
