4. INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT EO18-33031
4.3 PEEL-OFF MODULE (B-EX906-H-QM-R)
4-23
6. Fit the Front Panel (Right) to the printer.
7. Re-install the Side Panel (L).
NOTE:
The backing paper can be wound directly onto the Take-up
Spool or a paper core. When using the Take-up Spool, detach
the holder stopper by removing the B-3x5 screw. Otherwise, it
may be difficult to pull out the wound backing paper roll. When
using a paper core, put the core on the Take-up Spool with the
Holder Stopper on it, and attach the top edge of the backing
paper to the core with adhesive tape. The Take-up clip is not
necessary.
Selection Switch
Holder Stopper
Take-up Spool
B-3x5
Screw
Take-up Clip
To Next Page
Loading...
