4. INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT EO18-33031
(Revision Date: Mar. 1, 2017)
4.6 Parallel Interface Board (B-EX700-CEN-QM-R)
4-35
5. Fit the parallel interface connector of the parallel interface board into the slot from the inside, and secure
it with the two M-3x6 screws from the outside, as shown below.
6. Connect the interface cable to J2 on the Main PC board.
7. Re-install the Side panel (L).
8. Refer to Section 5.9.4 CENTRONICS in 5.9 INTERFACE for the interface parameter settings.
M-3x 6 Screw
Parallel Interface
Connector
Main PC Board
J2
Interface Cable
Parallel Interface Board
To Next Page
Loading...
