Toshiba B-EX6 Series - Page 71

4. INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT EO18-33031
(Revision Date: Mar. 1, 2017)
4.8 UHF RFID KIT (B-EX706-RFID-U4-US/EU/AU-R)
4-54
(3) READ RETRY
● The number of times a tag read is retried
● Read retry timeout
(4) WRITE RETRY
● The number of times a tag write is retried
●
Write retry timeout
255
0
254
1
9.9 sec.
0.0 sec.
9.8 sec.
0.1 sec.
Set a maximum number of retries to read an RFID tag.
The printer retries to read the data in an RFID tag for up to specified
number of times. If the timeout period expired before the max. number
retries have been done, the printer stops the retries at the time.
Whenever the printer writes data onto an RFID tag, the tag is read first.
The max. number of retries set by this parameter becomes also effective
in this pre-read.
Set the timeout period during which RFID tag read retries are allowed,
with the [UP] or [DOWN] key. If the printer has retried for the max.
number of times within the RFID read retry timeout, the printer stops
the retries at the time.
Whenever the printer writes data onto an RFID tag, the tag is read first.
The read retry timeout set by this parameter becomes also effective in
this pre-read.
255
0
254
1
9.9 sec.
0.0 sec.
9.8 sec.
0.1 sec.
Set a maximum number of retries to write data onto an RFID tag.
The printer retries to write data onto an RFID tag for up to specified
number of times. If the timeout period expired before the max.
number of retries have been done, the printer stops the retries at the
time.
Set the timeout period during which RFID tag write retries are
allowed, with the [UP] or [DOWN] key.
If the printer has retried for the max. number of times within the RFID
write retry timeout, the printer stops the retries at the time.