4. INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT EO18-33031
(Revision Date: Oct., 2018)
4.9 4” ROTARY CUTTER (B-EX206-R-QM-S)
4-69
9.4.5 Cut Angle Adjustment
When the cutter cuts media obliquely, adjust the cut angle using the following procedure.
1. Loosen the two SM-4 x8B screws.
2. Move the guide plate back or forth so that the cutter is perpendicular to the media. Tighten the same SM-
4x8B screws.
<As viewed from the top of the cutter unit>
3. Perform a test cut to check for a proper operation. Repeat the procedure, if necessary.
SM-4x8B Screw
Guide Plate
SM-4x8B Screw
To Next Page
Loading...
