5. SYSTEM MODE EO18-33031
5.4 DIAGNOSTIC
5-5
4-4 When an error occurred during printing
CHECKING & PRINT
RIBBON ERROR
The printer displays the error message, and stops.
The ERROR LED turns on and the ONLINE LED turns
off.
1. Press the [ENTER] or [CANCEL] key.
2. PRINT TYPE menu is displayed.
Note: When the [MODE] key is pressed, the top menu
of the SYSTEM MODE is displayed
PRINT TYPE C1.6
â–²
DIRECT THERMAL
â–¼
THERMAL TRANSFER
DISPLAY
The printer recovers from the error, the ERROR LED
turns off and the ONLINE LED turns on.
Note that the printer does not reprint the label
automatically.
5. In the case DISPLAY is selected:
5-1
PRINT TYPE C1.6
â–²
DIRECT THERMAL
â–¼
THERMAL TRANSFER
DISPLAY
1. Select DISPLAY.
2. Press the [ENTER] key.
3. DISPLAY menu is displayed.
5-2
DISPLAY
â–²
COUNTER
ADJUSTMENT(PC)
USB SERIAL NUMBER
â–¼
STORAGE AREA
1. Select an item to be displayed.
2. Press the [ENTER] key.
3. The data of the selected item is displayed.
5-3
COUNTER
â–²
TOTAL FEED 4.8km
FEED 0.0km
FEED1 4.8km
FEED2 0.0km
â–¼
For details of the Maintenance counter data, refer to
Section 5.4.1.1 Counter Parameter Print Contents.
To Next Page
Loading...
Need help?
General
