Setting up from TopAccess 135
9) IP Address
Enter the static IP address that is assigned to this equipment when “Static IP” is selected in
the “Address Mode” drop down box.
10) Subnet mask
Enter the subnet mask if required when “Static IP” is selected in the “Address Mode” drop
down box.
11) Default Gateway
Enter the gateway address if required when “Static IP” is selected in the “Address Mode”
drop down box.
12) IP Filtering
When you want to set the IP filtering for Raw TCP, LPR, and IPP printing, specify the range
of IP addresses in the Start Address and End Address fields.
When you specify the range of IP addresses, only the client that the specified IP address
range is assigned can perform Raw TCP, LPR, and IPP printing.
IP Filtering can restrict the accesses for Raw TCP, LPR, and IPP printing in the IPv4 net-
work. The accesses using other protocols are not restricted.
To Next Page
Loading...
Need help?
General
