E6582062
3. [Basic operation] Operation panel and screen display 3-4
3
9
■ Parameter information
You can see QR code for the parameter when the parameter is selected or edited.
↓Press[i] key
• [STOP/RESET] key
This key is used for a stop command from the operation panel.
To enable the stop command by this key, set "1" to the parameter <CMOd: Run command select>.
For details, refer to [5. 2. 1].
Emergency off can be applied to the inverter except when it is operated by the operation panel. When
you press this key, blinks. When you press it again, "E" is displayed and the emergency off is
applied.
For details, refer to [3. 2. 3].
It is also used as a reset key when a trip occurs. The inverter can be reset by pressing this key twice in
succession when a trip occurs.
For details, refer to [3. 2. 4].
• Touch wheel
Slide your finger in a circular motion to change the menu items and values on the screen.
Turning clockwise: To move to the next item or increase the value.
Turning counterclockwise: To move to the previous item or decrease the value.
When you lightly touch the top or bottom of the circle, you can move to that direction by one item. For
example, if you touch the top of the circle continuously, it works similarly to turning clockwise.
•[OK] key
This key is used to confirm the menu items and values on the screen.
dEC : Deceleration time 1
Sr0 : Preset speed 0
Sr1 : Preset speed 1
ACC : Acceleration time 1
LL : Lower limit frequency
Top
0.0HzSTOP
10:01
10.0s
0.0Hz
0.0Hz
10.0s
0.0Hz
Basic parameters
F R
0.0HzSTOP
10:02
ACC :Acceleration time 1
Scan the QR code to
access the detailed
information
ESC =Return
Top MonitorReturn
F R
To Next Page
Loading...
