E6582062
6. [Advanced] How to use parameters 6-26
4
4
6
9
When you want to output the set maximum frequency at the maximum voltage and current values,
decrease the gain value for a corresponding terminal.
However, if the set value is too small, the maximum frequency may not be output even when voltage
and current reach the maximum values.
Reference
• How to operate the operation panel -> Refer to [3. 1. 1].
• How to switch display mode on the operation panel -> Refer to [3. 1. 2].
• Procedure to change parameter setting -> Refer to [4. 2. 3].
• Details on operation by external signals -> Refer to [Chapter 7].
To Next Page
Loading...
