8
2. Open Telnet, then type telnet 192.168.0.1 in the command prompt shown as Figure 1-8, and
press the En
ter button.
Figure 1-8 Connecting to the Switch
3. Type the default user name and password admin/admin, then press the Enter button so as to
enter User EXEC Mode.
Figure 1-9 Enter into the User EXEC Mode
Now you can manage your switch with CLI commands through Telnet connection.
4. Type enable command to enter Privileged EXEC Mode. A password that you have set
through Console port connection is required. Here the password is set as 123.
To Next Page
Loading...
