TSAT 3000 - Page 117

TSAT 3000 - Telemetry and data transfer via SATellite
TSAT 3000 Configuration Parameter Description, January 2013 Page 117 of 124
16
0x0001.0000
UTILITY_ADJUST_TCXO
RT Ver >= 30.2.0: Enable adjustments of local TCXO.
See
DAC_{TCXO | OCXO}_REF.
17
0x0002.0000
UTILITY_ALSO_LOG_LOW_
SIGNAL_CRC_ERRORS
CCU will normally discard false CRC errors detected by
DSP. I.e. Not report CRC errors with E
b
/N
0
< 3.0 dB +
UW position close (+/- 5 symbols) to
PHL_TARGET_UW_POSITION.
When enabled, also these CRC errors will be reported.
18
0x0004.0000
n/a
19
0x0008.0000
UTILITY_AUTO_STATISTICS_
DISABLE
Don’t send link statistics (copy of all SYNC packets) to
Service Ports.
20
0x0010.0000
UTILITY_NO_PIGGYBACK
Don’t include Secure-Link piggy-back acknowledge in
Non
-Secure-Link APPLICATION and NETWORK packets.
See
LCC_WINDOW_SIZE.
21
0x0020.0000
n/a
22
0x0040.0000
n/a
23
0x0080.0000
n/a
24
0x0100.0000
n/a
25
0x0200. 0000
n/a
26
0x0400.0000
n/a
27
0x0800.0000
n/a
28
0x1000.0000
UTILITY_SATELLITE_
SIMULATOR
Ver >= 31.5.3: Enable L-Band Satellite Simulator.
That is to disable Power and 10MHz to LNB/BUC,
and RT to calculate correct frequency K-factor.
29
0x2000.0000
UTILITY_REBOOT_
CONTINEOUSLY
Ver >= 31.8.3: Reboot modem as soon as CCU is
started. I.e. approx. each 75 sec.
30
0x4000.0000
UTILITY_TEST_GAIN_
WITH_MANY_RTS
HUB Ver >= 30.3.1: Slow regulation of Rx E
b
/N
0
to
simulate a network with
NET_NO_OF_RTS RTs.
31
0x8000.0000
UTILITY_DONT_CHANGE_
OTHER_TASK_PRIORIY
Don’t change running priority of “tShell” and other tasks
while CCU is running.