TSC TTP-244 Plus Programming Manual

TSC AUTO ID Technology Co., Ltd. 129 Copyright 2013 All Rights Reserved.
 COPY
Description
Copy the existed file from CARD to FLASH.
Syntax
COPY [memory ID of source,]"filename of source",[memory ID of new file,]"new filename"
Parameter
Description
memory ID of source
Optional.
ID
Memory device
Omitted
DRAM
F
FLASH
E
CARD
source filename
The file in CARD which you want to copy to on board FLASH.
memory ID of new file
Optional.
ID
Memory device
Omitted
DRAM
F
FLASH
new filename
The new filename you want to use in the on board FLASH.
Note: This command has been supported since V6.78 EZ and later firmware.
Example
See Also
DOWNLOAD, EOP, OPEN, FREAD$(), EOF, LOF(), SEEK, CLOSE
Sample Code
DOWNLOAD "DATA_D.DAT",105,We stand behind our products with one of the most comprehensive support
programs in the Auto-ID industry.
DOWNLOAD "TEST.BAS"
KILL F,"*"
COPY "DATA_D.DAT",F,"DATA_F.DAT"
OPEN "DATA_F.DAT",0
SEEK 0,0
data$=FREAD$(0,LOF("DATA_F.DAT"))
CLOSE 0
SIZE 4,0.5
GAP 0,0
CLS
BOX 10,10,800,100,2
BLOCK 15,15,790,90,"0",0,8,8,20,2,data$
PRINT 1
EOP
TEST
Result
203 dpi
300 dpi

TSC TTP-244 Plus Specifications

General

Resolution	203 dpi
Print Speed	4 ips
Print Method	Thermal Transfer / Direct Thermal
Weight	2.5 kg
Max. Print Width	4.25 inches
Max. Print Length	90 inches
Processor	32-bit RISC CPU
Interface	RS-232
Label Width	1 inch to 4.4 inches
Power Supply	100-240V AC, 50/60Hz
Operating Temperature	5°C to 40°C
Storage Temperature	-40°C to 60°C
Humidity	25% to 85% non-condensing
Label Thickness	0.06 ~ 0.19 mm (2.36 ~ 7.48 mil)
Dimensions	232 mm (W) x 156 mm (H) x 288 mm (D)