TSC TTP-244 Plus Programming Manual

TSC AUTO ID Technology Co., Ltd. 190 Copyright 2013 All Rights Reserved.
 SET RIBBON
Description
This setting is used to enable/disable ribbon sensor detection. (Thermal Transfer Printing/Thermal
Direct Printing) Printer will detect the presence of a ribbon to determine using either direct thermal or
thermal transfer printing upon printer startup. This setting will NOT be saved in printer memory.
Syntax
SET RIBBON ON/OFF/INSIDE/OUTSIDE
Parameter
Description
ON
Thermal transfer printing
OFF
Thermal direct printing
INSIDE
The ribbon is inside wound. For TTP-384M only. *Since V6.80EZ.
OUTSIDE
The ribbon is outside wound. For TTP-384M only. *Since V6.80EZ.
Example
Sample Code
REM *****Disable ribbon detection sensor for direct thermal printing.
SET RIBBON OFF
SIZE 4,1
GAP 0,0
CLS
TEXT 10,10,"3",0,1,1,"Direct thermal printing."
PRINT 1
REM *****Enable ribbon detection sensor for thermal transfer printing.
SET RIBBON ON
SIZE 4,1
GAP 0,0
CLS
TEXT 10,10,"3",0,1,1,"Thermal transfer printing."
PRINT 1
REM *****For using ink-in ribbon in TTP-384M.
SET RIBBON INSIDE
SIZE 4,1
GAP 0,0
CLS
TEXT 10,10,"3",0,1,1,"TTP-384M is using ink-in ribbon."
PRINT 1
REM *****For using ink-out ribbon in TTP-384M.
SET RIBBON OUTSIDE
SIZE 4,1
GAP 0,0
CLS
TEXT 10,10,"3",0,1,1,"TTP-384M is using ink-out ribbon."
PRINT 1

TSC TTP-244 Plus Specifications

General

Resolution	203 dpi
Print Speed	4 ips
Print Method	Thermal Transfer / Direct Thermal
Weight	2.5 kg
Max. Print Width	4.25 inches
Max. Print Length	90 inches
Processor	32-bit RISC CPU
Interface	RS-232
Label Width	1 inch to 4.4 inches
Power Supply	100-240V AC, 50/60Hz
Operating Temperature	5°C to 40°C
Storage Temperature	-40°C to 60°C
Humidity	25% to 85% non-condensing
Label Thickness	0.06 ~ 0.19 mm (2.36 ~ 7.48 mil)
Dimensions	232 mm (W) x 156 mm (H) x 288 mm (D)