TSC TTP-244 Plus Programming Manual

TSC AUTO ID Technology Co., Ltd. 28 Copyright 2013 All Rights Reserved.
 LIMITFEED
Description
If the gap sensor is not set to a suitable sensitivity while feeding labels, the printer will not be able to
locate the correct position of the gap. This command stops label feeding and makes the red LED flash if
the printer does not locate gap after feeding the length of one label plus one preset value.
Syntax
LIMITFEED n[,minpaper,maxgap]
English system (inch)
LIMITFEED n mm[,minpaper
mm,maxgap mm]
Metric system (mm)
LIMITFEED n dot[,minpaper
dot,maxgap dot]
Dot measurement
This command has been supported since V6.34 EZ.
Parameter
Description
N
The maximum length for sensor detecting
Minpaper
The minimum length of paper
Maxgap
The maximum length of gap
Note:
 The setting will remain resident in memory.
 For metric system, there must be a space between parameter n and mm.
 The default value is 10 inches when printer initializes.
 Since V6.76 EZ, the default value for TDP-225 series printer is 14 inches when printer
initializes.
 The setting of parameters “mimpaper” and “maxgap” are using for calibrating the
preprinted label. This parameter has been supported since V6.98.7 EZ.
Example
Sample code
 English system (inch)
LIMITFEED 12

TSC TTP-244 Plus Specifications

General

Resolution	203 dpi
Print Speed	4 ips
Print Method	Thermal Transfer / Direct Thermal
Weight	2.5 kg
Max. Print Width	4.25 inches
Max. Print Length	90 inches
Processor	32-bit RISC CPU
Interface	RS-232
Label Width	1 inch to 4.4 inches
Power Supply	100-240V AC, 50/60Hz
Operating Temperature	5°C to 40°C
Storage Temperature	-40°C to 60°C
Humidity	25% to 85% non-condensing
Label Thickness	0.06 ~ 0.19 mm (2.36 ~ 7.48 mil)
Dimensions	232 mm (W) x 156 mm (H) x 288 mm (D)