TSC TTP-244 Plus

TSC AUTO ID Technology Co., Ltd. 8 Copyright 2013 All Rights Reserved.
 OFFSET
Description
This command defines the selective, extra label feeding length each form feed takes, which, especially
in peel-off mode and cutter mode, is used to adjust label stop position, so as for label to register at
proper places for the intended purposes. The printer back tracks the extra feeding length before the
next run of printing.
Syntax
OFFSET m
English system (inch)
OFFSET m mm
Metric system (mm)
OFFSET m dot,n dot
Dot measurement
This command has been supported since V6.27 EZ and later firmware.
Parameter
Description
m
The offset distance (inch or mm)
-1 ≤ m ≤ 1 (inch)
CAUTION:
 Impropriety offset value may cause paper jam.
 For metric system, there must be a space between parameter and mm.
 200 DPI : 1 mm = 8 dots
300 DPI : 1mm = 12 dots
Example
Sample Code
 English system (inch):
OFFSET 0.5
 Metric system (mm):
OFFSET 12.7 mm
See Also
SIZE, GAP, SET PEEL, SET CUTTER