125
13 Options
125
Options
Chapter
13
■ Communication type
- Mode = 0: Command
Communication is commanded from the host computer.
(Indicated value will not be automatically transmitted.)
Terminators can be selected from CR or CR+LF.
- Mode = 1: Continuous
Message in UNI-Format is continuously transmitted.
R, W, and C commands are ignored.
Format 1: status, indicated value linked
Format 2: status, indicated value linked, indicated value not linked
Format 3: status, indicated value linked
* Outputs of HH limit and LL limit are excluded from Format 1.
- Mode = 2: Printed
Message in the UNI-Format is transmitted when printing is performed.
Format 1: status, indicated value linked
Format 2: status, indicated value linked, indicated value not linked
Format 3: status, indicated value linked
* Outputs of HH limit and LL limit are excluded from Format 1.
Transmitting format 1 (21 or 22-byte)
Transmitting format 2 (24-byte)
Transmitting format 3 (19 or 20-byte)
Transmitting format 1 (21 or 22-byte)
Transmitting format 2 (24-byte)
Transmitting format 3 (19 or 20-byte)
Refer to P.132 “■ Continuous transmitting format” for transmitting specifications.
Attention
To Next Page
Loading...