10.4. Passwords
Description You can create and manage different types of password in PolyScope. An initial
password must be set to access the full safety settings. The following password types are
described below:
•
Administrator
•
Operational
10.5. Password Settings
To set a
Password
You must set a password to Unlock all safety settings that make up your Safety
Configuration. If no safety password is applied, you are prompted to set it up.
1. In your PolyScope header right corner, press the Hamburger menu and select
Settings.
2. On the left of the screen, in the blue menu, press Password and select Safety.
3. In New password, type a password.
4. Now, in Confirm new password, type the same password and press Apply.
5. In the bottom left of the blue menu, press Exit to return to previous screen.
You can press the Lock tab to lock all Safety settings again or simply navigate to a screen
outside of the Safety menu.
UR30 165 User Manual
10.Cybersecurity Threat Assessment
Copyright © 2009–2024 by UniversalRobotsA/S. All rights reserved.
To Next Page
Loading...
