Universal Robots UR30 - First Boot; Starting Your Robot

7.First Boot
Description The first boot is the initial sequence of actions you can take with the robot after assembly.
•
This initial sequence requires you to:
•
Start the robot
•
Insert the serial number
•
Intialize the robot arm
•
Power down the robot
While the robot arm is powered on you can use Freedrive to move the robot.
The robot arm requires ample space to operate freely.
CAUTION
Failure to verify the payload and installation before starting up the robot arm can
lead to injury to personnel and/or property damage.
•
Always verify the actual payload and installation are correct before
starting up the robot arm.
CAUTION
Incorrect payload and installation settings prevent the robot arm and Control Box
functioning correctly.
•
Always verify the payload and installation setting are correct.
NOTICE
Starting up the robot in lower temperatures can result in lower performance, or
stops, due to temperature dependent oil and grease viscosity.
•
Starting up the robot in low temperatures can require a warmup phase.
7.1. Starting your robot
User Manual 52 UR30
7.First Boot
Copyright © 2009–2024 by UniversalRobotsA/S. All rights reserved.