Universal Robots UR30 - Setting a Software Safety Password

9.4.1. Setting a Software Safety Password
Description You must set a password to Unlock all safety settings that make up your Safety
Configuration. If no safety password is applied, you are prompted to set it up.
To set a
Software
Safety
password
You can tap the Lock tab to lock all Safety settings again or simply navigate to a screen
outside of the Safety menu.
1. In your PolyScope header right corner, press the Hamburger menu and select
Settings.
2. On the left of the screen, in the blue menu, press Password and select Safety.
3. In New password, type a password.
4. Now, in Confirm new password, type the same password and press Apply.
5. In the bottom left of the blue menu, press Exit to return to previous screen.
UR30 139 User Manual
Copyright © 2009–2024 by UniversalRobotsA/S. All rights reserved.