Universal Robots UR30 - Page 215

(I) EN ISO 10218-1:2011 TÜV Nord
Certificate # 44 708 14097607 (I) EN ISO
13732-1:2008 as applicable (I) EN ISO
13849-1:2015 TÜV Nord Certificate # 44 207
14097610 (I) EN ISO 13849-2:2012 (I) EN
ISO 13850:2015
(I) (II) EN 60204-1:2018 as
applicable (II) EN
60529:1991+A1:2000+A2:2013 (I)
EN 60947-5-5:1997+A1:2005
+A11:2013+A2:2017 (I) EN 60947-5-
8:2020 (III) EN 61000-3-2:2019
(II) EN 60664-1:2007 (III) EN 61000-3-3:
2013 (III) EN 61000-6-1:2019 UR3e &
UR5e ONLY (III) EN 61000-6-2:2019 (III)
EN 61000-6-3:2007+A1: 2011 UR3e &
UR5e ONLY (III) EN 61000-6-4:2019
Reference to other technical standards and technical specifications used:
(I) ISO 9409-1:2004 [Type 50-4-M6] (I)
ISO/TS 15066:2016 as applicable (III) EN
60068-2-1: 2007 (III) EN 60068-2-2:2007
(II) EN 60320-1:2021 (III) EN 60068-
2-27:2008 (III) EN 60068-2-
64:2008+A1:2019
(II) EN 61784-3:2010 [SIL2] (III) EN
61326-3-1: 2017 [Industrial locations SIL
2]
The manufacturer, or his authorised representative, shall transmit relevant information about the partly
completed machinery in response to a reasoned request by the national authorities. Approval of full quality
assurance system (ISO 9001), by the notified body Bureau Veritas, certificate #DK015892.
User Manual 216 UR30
18.Declarations and Certificates (original EN)
Copyright © 2009–2024 by UniversalRobotsA/S. All rights reserved.