Communication Interfaces
VTK-TR-BA-072e-1 - User Manual MDS 358X Series
This command sets the cooler offset for the flow control valve which is
connected to the MDC. The value has to be between 0 % and 100 %. The
cooler offset allows for a constant airflow through the valve, even if the
regulation does not require an airflow yet. The value is given in percent, i.e.
allowed are integers between 0 and 100.
This command has the same function as the menu item “Cooler Offset” in
the submenu “Cooler”.
In case there is no flow control valve connected, the response is “NAK”.
The cooler offset is set to 10 %.
To Next Page
Loading...