The Main Menu
178
To access settings from the Monitoring or the Home Care
screen, rotate the control knob to highlight the desired selection
box. Press the knob to accept your selection. (For more
information on choosing mode, setting parameters, setting
alarms and browsing waveforms, refer to the index or to the
table of contents.)
The Home Care display shows the Mode, the Exhale Volume
and the Total Rate. It is designed primarily for the simplest
kind of monitoring. If you wish to change settings or view
ventilator information, change to the Main menu display.
To switch to any display, turn the control knob to highlight the
Menu selection box in the bottom right section of the screen,
and then press. Turn the control knob to highlight Display,
then select the desired screen.
4.11 O.V.T.
The O.V.T. (Operational Verification Test) tests the patient
circuit and the alarm sound. It must be performed every time a
new circuit is connected.
To start the O.V.T., highlight the Main menu selection box in
the bottom right corner of the screen and press the control
knob. Turn the control knob to select O.V.T. from the Main
menu. Follow the on-screen directions. (For more information,
see Section 3.3.2.)
4.12 Maintenance
The Maintenance screen is described with maintenance
procedures in Section 7.
To Next Page
Loading...
