iVent201 Operator's Manual
235
7.7 Communication Rate
The iVent
201
has a serial port installed for remote
communication with other devices. The default data transfer
rate is 115,200 bps. Ordinarily there should be no reason to
change this setting. If you wish to change the communication
rate:
1. From the Maintenance screen
dial the control knob to
highlight ”Communication
Rate,” then press.
2. A pop-up will appear offering a
range of choices: 1200, 2400,
4800, 9600, 19200, 38400, 57600,
and 115200. Make the desired
selection and press the knob
again.
The Maintenance screen will return with the selected
communication rate highlighted. The ventilator will
restart with the new communication rate.
7.8 Localization
Localization is used to change the language set for the iVent
201
.
WARNING: Do not access the Localization menu unless
you are sure you wish to change the language the
iVent
201
uses. Remember, if you change the selected
language, you will change all the menus.
If you wish to change the selected language the iVent uses for
all screens, menus, and messages:
To Next Page
Loading...
