VersaMed iVent201 - Page 94

Operating the iVent201 – Setting Modes and Parameters
82
When you have chosen the new value, press the control knob to
confirm and accept.
Note: Certain modes and values described in this section
are not operational in all iVent
201
models.
Notes:
a) When the setting for
Inspiratory Time is
“Adaptive” the value to
reach I.E. ratio 1:2 is
displayed. Once this
value reaches 2 seconds,
it does not change since
the Adaptive
Respiratory algorithm
does not allow T
insp
above 2 seconds.
b) When the setting for
Inspiratory Time is
“Manual” this set value
is continuously
displayed at all breath
rate values.