21. Pull the lower opening of the bellow upwards over
the spindle until it stops and hold the bellow in this
position.
The holes for the screws used to fasten the bellow
must be located on the corresponding screw holes
in the spindle holder.
FIG. 152
FIG. 153
22. Carefully move the spindle unit by hand in the X
and Y directions until the bellow is not taut at any
point.
23. Use the TX25 angle screwdriver to tighten the
bellow with 3 screws in the front screw holes:
a. Carefully place the first screw and check if you
can screw it in. If this is not possible, correct
the position of the bellow.
b. Screw in all screws first without tightening
them. This allows you to correct the position
of the bellow.
c. When you have properly screwed in all the
screws, tighten them.
Maintenance
EN 63
Original Operating Instructions: E5
Version: 4/27/2023
To Next Page
Loading...
