Page: 1-32
WALKER MANUFACTURING COMPANY
July 2006
SERVICE INSTRUCTIONS
Model MS, MB, MC, MD, MT, MTL, MTEFI
3. Remove the PTO cover (between the footrests).
Remove the shipping wire from the counterweight
springs, place the lift handle in the UP (back)
position, and hook the counterweight springs onto
the hook tabs on the frame. The tabs are located
below the right angle gearbox and drive shaft (refer
to Counterweight Spring Hook Tab Locations
photo).
Counterweight Spring Hook
Tab Locations (bottom view)
4. Install the spout assembly.
Install Spout Assembly
a. Place the chute on the chute base and align
the holes of the three (3) retaining plates
with the holes in the chute base. Attach the
rear and right hand side retaining plates with
one (1) 1/4-20 x 1/2 bolt in the forward most
hole and the front retaining plate with two (2)
1/4-20 x 1/2 bolts and secure with four (4)
1/4-20 flange nuts.
b. Insert the two (2) 1/4-20 x 1-3/4 bolts in the
rotation stopper, the spacer rings and through
the remaining holes of the rear and right hand
side retaining plates and secure in place with
two (2) 1/4-20 nuts. Tighten the nuts firmly.
c. Insert one (1) grommet in rotation support
and one (1) grommet in handle support,
mount handle support and rotation handle to
blower using two (2) 1/4-20 x 1/2 bolts and
two (2) 1/4-20 flanged nuts.
d. Install 1/2” plastic handle on rotation handle.
5. Lightly grease the tractor support arms.
6. Engage the snowblower mounting tubes on the
tractor support arms.
Engage Snowblower Mounting Tubes
with Tractor Support Arms
7. Slide the snowblower onto the tractor support arms
and connect the snowblower PTO shaft to the trac-
tor with the PTO quick coupler as follows:
NOTE: Model MS and earlier Model MC do not
have the PTO quick coupler. Use sliding joint to
connect tractor to snowblower PTO.
a. Place the pilot end of the snowblower PTO
shaft into the socket of the PTO quick coupler
and rotate the PTO shaft until it is aligned cor-
rectly with the socket in the PTO quick cou-
pler, then slide together. Use arrows on the
shaft and tube for correct alignment.
Remove PTO Cover Before
Attaching Springs To Frame
Spring Hook Tabs
Spout Discharge
Guard
(not shown)
Mounting Tubes
Support Arms
To Next Page
Loading...
Need help?
General
