110 Creating PowerLine Methods
Deleting Lines
To delete individual lines from a table:
1. Move the cursor to any field on the line you want to delete.
2. Press the Clear Line screen key. This immediately clears the line the cursor is on and
moves succeeding lines in the table up one line. The cursor remains in the original
field.
Inserting Lines
To insert a line into a table:
1. Move the cursor to the end of the table in the Time column.
2. Type the time for the new line. The table automatically sorts the lines according to
time and inserts the new line in the proper location.
3. Enter values for the other parameters on the new line.
If the new line appears at the end of the table, the system copies the values from the
previous line into the new line. Edit the copied conditions as necessary.
Saving Tables
Note: Whenever you change a table, you must save the changes before leaving the
screen or powering down the system.
The system does not retain parameter values that you have not saved. When you turn on
the system at a later time, the last table saved is the default.
To save a table after all changes have been entered:
1. Press the Save screen key. The system displays:
Enter Table Number (1-15)
2. Type the number under which to save the table. Press Enter. The screen displays:
Replace With New Table? 1 = Yes 0 = No
If you enter a table number for a table that already exists, that preexisting table
appears.
3. To overwrite the preexisting table, type 1. This erases the contents of the preexisting
table.
If you do not want to overwrite the preexisting table, type 0. The screen displays the
newly created table again.
To Next Page
Loading...
