180 Creating Gradient Controller Time-Based Tables
8. Repeat steps 3 through 7 for each line in the gradient.
When entering information for subsequent lines in the table, enter the time value for
each line and press Enter. This action copies the values from the previous line to the
new line.
9. If desired, enter a line to return to initial conditions.
10. If desired, enter a line to reduce the flow rate.
Press the Save screen key to save the table in permanent memory. When prompted, enter a
table number between 1 and 15 and press Enter.
10.1.4 Editing the Gradient Table
This sections describes the following editing functions:
• Deleting lines
• Inserting lines
• Saving tables
• Replacing and deleting tables
These procedures apply to:
• Gradient tables
• Event tables
Deleting Lines
To delete individual lines from a table:
1. Move the cursor to any field on the line you wish to delete.
2. Press the Clear Line screen key. This immediately deletes the line the cursor is on
and moves succeeding lines in the table up one line. The cursor remains on the
original field.
Inserting Lines
To insert a line into a table:
1. Move the cursor to the Time field in a new line just below the last line in the table.
2. Type the time for the new line. The table automatically sorts the lines according to
time and inserts the new line in the proper location.
3. Enter the parameter values for the new line.
To Next Page
Loading...
