130 Creating PowerLine Methods
5. At the Inj Vol field, type the sample volume for all injections. Press Enter.
• When using a Waters autosampler (717plus), the maximum volume is determined
by the loop size (200 µL or 2000 µL) installed in the autosampler.
• When using the manual injector, a non-PowerLine autoinjector, or making prep
injections, this value is for documentation purposes only.
6. At the Run Time field, type the analysis run time (0.0 to 655.34 minutes). Press
Enter.
7. At the Tables # field, type the table number for the set of tables (gradient, event, and
detector) for this step. Press Enter.
8. Repeat steps 1 through 7 for each line in the Method table.
9. Save the table by pressing the Save screen key.
6.4.4 Editing the Method Table
This section describes the following editing functions:
• Deleting and inserting lines
• Saving and clearing tables
Deleting Lines
To delete individual lines from a table:
1. Move the cursor to the line you want to delete by doing the following:
a. Move the cursor to the Step column of the current line
b. Type the step number of the line you want to delete and press Enter. The cursor
moves immediately to the line you specified.
2. Press the Clear Line screen key. This immediately clears the line the cursor is on and
moves succeeding lines in the table up one line. The cursor remains in the original
field.
Inserting Lines
To copy and insert a line into a table:
1. Move the cursor to the line preceding the location of the new line by doing the
following:
a. Move the cursor to the Step column of the current line.
b. Type the step number of the line to which you want to move and pressing Enter.
The cursor moves immediately to the line you specified.
To Next Page
Loading...
