Waters 600e - 5.1 Setting Run Conditions

86 Running PowerLine in Direct Control Mode
• Familiarized yourself with basic operation and have decided upon a controller
configuration (Chapter 2, Basic Operation)
• Prepared your system as outlined in Chapter 3, Preparing Your 600E System for
Operation
• Set operating parameters as described in Chapter 4, Setting PowerLine Controller
Operating Parameters
5.1 Setting Run Conditions
Before you make a run with the PowerLine controller in the Direct Control mode, you
must first set the run conditions. This section describes the procedures for setting the
following run conditions:
• Pump parameters
• External event switches
• Autoinjector parameters
• Detector parameters
Figure 5-1 illustrates the steps involved in using the Direct Control screen. Use this figure
for quick reference once you become familiar with the 600E system.