Setting Up the 600E Pump 63
4.3 Setting Up the 600E Pump
This section describes how to access and use the Pump Setup screen in PowerLine Control
mode. It includes the following information:
• Accessing the Pump Setup screen
• Setting Pump Setup screen parameters
• Exiting the Pump Setup screen
Pump Setup Overview
The PowerLine Controller Pump Setup screen includes the following configuration
selections:
• Enable/disable reservoir sparging
• High-temperature limit for an optional column heater
• High and low operating-pressure limits for the system
• External chart output function
• Enable/disable a flow factor to account for flow path elasticity or eluent
compressibility
• Enable/disable and program autostart
• Lock/unlock keyboard
Figure 4-12 illustrates the steps for using the Pump Setup screen. Use Figure 4-12 as a
quick reference for setting the parameters on the Pump Setup screen.
To Next Page
Loading...
