Waters 600e - Selecting the Report Type

54 Setting PowerLine Controller Operating Parameters
5. If you do not want to select or change the report type, press the Configure screen
key to save your selections. The controller reboots and returns to the Powerup
screen.
6. Proceed with the following sections:
• Section 4.2, Verifying that PowerLine Devices Are Active
• Section 4.3, Setting Up the 600E Pump
4.1.3 Selecting the Report Type
If you connected a Waters 745B/746 Data Module to the RS-232 port, specify the type of
report to print as follows:
1. Move the cursor to the Print field.
2. Type the number for the desired report option:
• 0 for no report
• 1 for a short report (see Figure 4-8)
• 2 for an abridged report (see Figure 4-9)
• 3 for a full report (see Figure 4-10)
3. Press the Configure screen key to save your selections. The controller reboots and
returns to the Powerup screen.
4. Continue with Section 4.3, Setting Up the 600E Pump, to set up the pump for the
first time or to change your pump setup parameter values.