Waters 600e - 4.1 Setting Up the 600 as a PowerLine Controller

Setting Up the 600 as a PowerLine Controller 47
4.1 Setting Up the 600 as a PowerLine Controller
This section describes how to use the Pump Configuration screen to configure the Waters
600 Controller as a PowerLine Controller. It includes procedures for:
• Configuring the controller type
• Communicating with a data module (integrator)
• Selecting the report type
Figure 4-2 illustrates the steps involved in using the Pump Configuration screen. Use this
flowchart as a quick reference for setting the parameters on the Pump Configuration
screen.