Creating a Method Table 129
Entering a special vial code affects which parameters appear on that line. Some
parameters are not available when you use certain special vial codes.
3. At the Last Vial field, type the number of the vial from which you wish to make the
last injection. Press Enter.
Note: If you entered a special vial code (100 to 107) in step 2, do not enter a value
in the Last Vial field.
4. At the #Inj field, type a value between 1 and 9 to indicate the number of injections to
make from each sample vial. Press Enter.
Note: If you specified special vial codes 100 or 104 for the First Vial field, enter the
number of injections (1 to 9).
102 Purge 410 Purges the Waters 410 detector by placing
its flow path in the purge mode and
running initial conditions for the specified
run time.
103 Purge Inj Purges the PowerLine autoinjector (Waters
717plus) for 4.5 minutes using the autoin-
jector purge routine and initial conditions.
104 Prep Tells the controller to run in the prepara-
tive chromatography mode when the
sample is introduced into the flow path
from one of the eluent lines or through the
inlet manifold on the pump. Allows the
system to inject the sample without an
inject signal. Also runs blank gradients or
reequilibrates a column.
105 Auto Base Instructs the 431/432 detector (Detector 3)
to execute its auto-baseline routine.
106 Pos Polarity Instructs the 410 or 431/432 detector
(Detector 3) to operate with positive
polarity.
107 Neg Polarity Instructs the 410 or 431/432 detector
(Detector 3) to operate with negative
polarity.
Table 6-6 Special Vial Codes (Continued)
Vial Code Function Description
To Next Page
Loading...
