July 2019
4-32
Xerox® B210 Service Manual
REP 4.13
Initial Release
Repairs - Adjustments
6. Remove the following items, Figure 2:
a. Remove two Drive Gears.
b. Remove the snap-ring, then remove the Feed Clutch Bushing.
c. Release the latch, rotate the bushing, then remove two Feed Shaft Bushings.
d. Remove the Feed Assembly screw.
Figure 2 Feeder Drives
7. Remove two screws from the bottom of the Feed Assembly, F
igure 3.
Figure 3 Feeder Assembly Bottom Screws (Bottom View)
CAUTION
The Brackets holding the Registration Pinch Rolls and Guide are Spring Loaded. Maintain light
press
ure on the Brackets when removing them to avoid damaging or losing parts or personal
injury.
8. Remove two screws, then remove the Registration Pinch Rolls and Paper Guide Brack-
ets, F
igure 4.
Figure 4 Registration Pinch Rolls and Paper Guide Brackets
Clutch Bushing
Drive Gears
Screws
Feed Shaft Bushings
To Next Page
Loading...
