08/2012
4-48
WorkCentre 5021/5019
REP 15.1.2
Initial Issue
Repairs and Adjustments
8. Remove the Registration Roll. (Figure 2)
(1) Remove the E-Clip.
(2) Move the bearing in the direction of the arrow.
(3) Remove the Registration Roll.
Figure 2 j0lj41509
Replacement
1. To install, carry out the removal steps in reverse order.
2. When installing the Registration Clutch, align the Tab (x2, top and bottom) of the Registra-
tion Clutch to the Cutout (x2, top and bottom) of the gear. (Figure 3)
Figure 3 j0lj41512
3. When installing the Registration Clutch, align the Cutout of the Registration Clutch to the
Tab.
(Figure 4)
Figure 4 j0lj41510
To Next Page
Loading...
