2-18
CABLE ROUTING
1. Meter assembly
2. Handlebar
3. Handlebar switch (left)
4. Clutch switch
5. Clutch cable
6. Headlight control unit coupler (headlight
assembly side)
7. Clutch switch lead
8. Grip warmer coupler (left) (OPTION)
9. Meter assembly bracket
10. Auxiliary light coupler (auxiliary light side)
11. Auxiliary light coupler (wire harness side)
12. Clutch switch coupler
13. Handlebar switch coupler (right)
14. Handlebar switch lead (left) (to horn)
15. Horn
16. Brake hose
17. Headlight bracket
18. Wire harness
19. Handlebar switch lead (right)
20. Accelerator position sensor coupler
21. Front brake light switch coupler
22. Front brake light switch lead
23. Grip warmer coupler (right) (OPTION)
24. Wire harness (to headlight control unit)
25. Auxiliary DC jack coupler
26. Headlight control unit coupler (wire harness
side)
27. Headlight control unit
28. Front brake light switch
29. Handlebar switch (right)
30. Meter assembly coupler
31. Handlebar switch lead (left)
32. Handlebar switch coupler (right) (white)
A. Clamp the right lead of the handlebar switch
and front brake light switch lead to the
rounded part of the handlebar. Face the lock-
ing part of the plastic band forward. Face the
end of the plastic band downward. No spe-
cific order for routing.
B. Clamp the left lead of the handlebar switch
and clutch switch lead to the rounded part of
the handlebar. Face the locking part of the
plastic band forward. Face the end of the
plastic band downward. No specific order for
routing.
C. Route the clutch switch lead on the rear side
of the wire harness (to handlebar switch cou-
pler (right)).
D. Insert an auxiliary light coupler into the hole
of the meter assembly bracket.
E. Insert the clutch switch coupler into the hole
of the meter assembly bracket.
F. Route the handlebar switch lead (left)
(to horn) on the rear side of the wire harness.
G. Insert the clamp into the hole of the meter
assembly bracket.
H. Face the terminal of the horn inside.
I. Route the handlebar switch lead (right) on the
front side of the wire harness (to front brake
light switch).
J. Insert an accelerator position sensor coupler
into the hole of the meter assembly bracket.
K. Insert the front brake light switch coupler into
the hole of the meter assembly bracket.
L. Route the wire harness (to headlight control
unit) on the front side of the front brake light
switch lead.
M. Pass the front brake light switch lead into the
hole of the meter assembly bracket.
N. Route the clutch switch lead on the inside of
the damper.
O. Route the handlebar switch lead (left) (to
horn) lead on the inside of the damper.
P. Do not ride the damper over the meter
assembly bracket.
Q. Route the front brake light switch lead on the
inside of the damper.
R. Pass the handlebar switch lead (right) behind
the wire harness within the range of the fig-
ure.
To Next Page
Loading...
